how do I get chaos to recognize added characters?

Trel · Post by **Trel** » Thu Dec 30, 2004 2:31 am

what do I have to do to make chaos see the player models I've added after chaos was installed?

jb · Post by jb » Thu Dec 30, 2004 5:04 am

it should automagically if you added the proper setup to you Ut2004.ini file paths statement:

In your main UT2004.ini file:

[Core.System]
CacheRecordPath=../ChaosUT2/Records/*.ucl
Paths=../ChaosUT2/Animations/*.uk
Paths=../ChaosUT2/Maps/*.ut2
Paths=../ChaosUT2/Sounds/*.uax
Paths=../ChaosUT2/StaticMeshes/*.usx
Paths=../ChaosUT2/System/*.u
Paths=../ChaosUT2/Textures/*.utx

that should do it.

jeditobe1 · Post by **jeditobe1** » Thu Dec 30, 2004 6:42 am

Jb's answer was if you are doing it in regular UT2004. If you are doing it via the mod menu, i think it should work, but if all else fails you might try coping the upl files for the models to the UT2004\ChaosUT2\System directory.

However, you might try removing your ChaosUT2.ini (in the UT2004\ChaosUT2\System directory) and restarting the mod. This will regenerate a new version of the file based on current settings in normal UT2004, and should allow models to work.

Trel · Post by **Trel** » Thu Dec 30, 2004 4:04 pm

jeditobe1 wrote:Jb's answer was if you are doing it in regular UT2004. If you are doing it via the mod menu, i think it should work, but if all else fails you might try coping the upl files for the models to the UT2004\ChaosUT2\System directory.

However, you might try removing your ChaosUT2.ini (in the UT2004\ChaosUT2\System directory) and restarting the mod. This will regenerate a new version of the file based on current settings in normal UT2004, and should allow models to work.

I think this would be what it is.

Trel · Post by **Trel** » Fri Dec 31, 2004 2:20 am

and it was